Cisco ASR 9000 Series Command Reference

dynamic-template type service
To group a set of configuration items that can be applied to a group of subscribers based on the service template
type and to enter the dynamic-template configuration mode, use the dynamic-template type service command.
To disable this feature and exit the dynamic-template configuration mode, use the no form of this command.
dynamic-template type service template-name
no dynamic-template type service template-name
Syntax Description
Specifies the dynamic template name.
template-name
Command Default
None
Command Modes
Dynamic template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
Use the dynamic-template command to enter dynamic template configuration mode.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This is an example of configuring the dynamic-template type service command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type service s1
Related Commands
DescriptionCommand
Enables the dynamic template
configuration mode.
dynamic-template, on page 232
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
238
Dynamic Template Commands
dynamic-template type service

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model