Cisco ASR 9000 Series Command Reference

vrf (dynamic-template-BNG)
To set the vrf in which the interface operates, use the vrf command in the dynamic template type configuration
mode. To disable the VRF, use the no form of this command.
vrf vrf-name
no vrf
Syntax Description
Specifies the name of the vrf.
vrf_name
Command Default
None
Command Modes
Dynamic template type configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
Use the dynamic-template command to enter dynamic template configuration mode.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This is an example of configuring the vrf command in the dynamic template type configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type service s1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# vrf vrf1
Related Commands
DescriptionCommand
Enables the dynamic template configuration mode.dynamic-template, on page 232
Enables the ppp dynamic template type.dynamic-template type ppp, on page 236
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
248
Dynamic Template Commands
vrf (dynamic-template-BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model