interface subscriber-pppoe profile
To enable the PPPoE subscribers to use a profile for all the PPPoE subscribers, use the interface
subscriber-pppoe profile command in the DHCP IPv6 configuration mode. To disable this feature, use the
no form of this command.
interface subscriber-pppoe profile profile_name
no interface subscriber-pppoe profile profile_name
Syntax Description
Specifies the name of the profile.
profile_name
Command Default
VRF is disabled.
Command Modes
DHCP IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeip-services
Examples
This is an example for enabling PPPoE subscribers to use the "my-def-pppoe-green" profile for all the PPPoE
subscribers using the interface subscriber-pppoe profile command:
RP/0/RSP0/CPU0:router(config)# dhcp ipv6
RP/0/RSP0/CPU0:router(config-dhcpv6)# interface subscriber-pppoe profile my-def-pppoe-green
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
164
BNG DHCP Commands
interface subscriber-pppoe profile
To Next Page
Loading...
