dhcpv6 delegated-prefix-pool
To specify the default pool name for (IA-PD) prefix delegation when no pool name or prefix is provided by
the Radius, use the dhcpv6 delegated-prefix-pool command in the dynamic template configuration mode.
To remove the delegated prefix pool name, use the no form of this command.
dhcpv6 delegated-prefix-pool pool_name
no dhcpv6 delegated-prefix-pool pool_name
Syntax Description
Specifies the name of a delegated prefix pool for DHCPv6.
pool_name
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enter the dynamic template configuration mode, enter dynamic-template command in the Global
Configuration mode.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
This is an example of creating a delegated prefix-pool name using the dhcpv6 delegated-prefix-pool
command:
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ipsubscriber ipsub1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# dhcpv6 delegated-prefix-pool myPool
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
151
BNG DHCP Commands
dhcpv6 delegated-prefix-pool
To Next Page
Loading...
Need help?
General
