Cisco ASR 9000 Series Command Reference

rapid commit
This command aids to enable or disable the rapid commit option of the DHCP server. Enabling it renders the
DHCPv6 server to use the two message exchange feature to address/prefix an assignment. Including the rapid
commit option in the SOLICIT message and enabling the same in the server profile, enables the server to
respond with the REPLY message. Else, it follows the normal four message exchange procedure to assign
address/prefix an assignment.
rapid-commit
no rapid-commit
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
DHCP IPv6 server profile configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationsTask ID
read, writeip-services
Examples
This is an example of enabling rapid-commit in the DHCP IPv6 server profile configuration mode:
RP/0/RSP0/CPU0:router(config)# dhcp ipv6
RP/0/RSP0/CPU0:router(config-dhcpv6)# profile my_profile server
RP/0/RSP0/CPU0:router(config-dhcpv6-server-profile)# rapid-commit
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
182
BNG DHCP Commands
rapid commit

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model