Cisco ASR 9000 Series Command Reference

ModificationRelease
The support for threshold and traffic keywords
were added.
Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
In Cisco IOS XR software release 4.2.1, both the IPoE and PPPoE sessions are retained idle, when the idle
timeout period expires. In Cisco IOS XR software release 4.2.3, only the IPoE sessions are terminated when
the idle timeout period expires. Whereas, the PPPoE sessions are retained idle. From Cisco IOS XR software
release 5.1.0 and later, both IPoE and PPPoE sessions are terminated on the expiry of the idle timeout period.
If packets sent or received by BNG, in the configured threshold interval is less than that threshold value, then
that particular session is considered idle. For instance, if the threshold is configured as 2 packets/minute,
and, if the number of packets received in every 2 minutes is only less than 2 (either 0 or 1), then that particular
session is considered as idle. Whereas, if the number of packets received is 2 or above, then that session is
considered as active.
By default, the sessions are disconnected if the threshold is not configured.
Task ID
OperationTask ID
read, writeconfig-services
Examples
This example shows how to configure an idle timeout of 200 seconds, with a threshold of 2 minutes/packet
and considering inbound and outbound traffic for determining the duration of session idleness:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp ppp1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# timeout idle 200 threshold 2 traffic
both
Related Commands
DescriptionCommand
Displays the feature accounting information of the
subscriber.
show subscriber feature accounting, on page 545
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
247
Dynamic Template Commands
timeout idle

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model