Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

ipsubscriber l2-connected

To enable l2-connected IP subscriber for IPv4 or IPv6, use the ipsubscriber l2-connected command in the

interface configuration mode. To disable this feature, use the no form of this command.

ipsubscriber {ipv4| ipv6} l2-connected initiator {dhcp| unclassified-source [address-unique]}

no ipsubscriber {ipv4| ipv6} l2-connected initiator {dhcp| unclassified-source [address-unique]}

Syntax Description

Specifies IPv4 address prefixes.ipv4

Specifies IPv6 address prefixes.ipv6

Configures the IP subscriber initiator.initiator

Configures DHCP as first-sign-of-life protocol for

IPv4 subscriber.

dhcp

Configures unclassified packets as first-sign-of-life

for IPv4 subscriber.

unclassified-source

Enables subscriber IP uniqueness check during

first-sign-of-life processing.

address-unique

Command Default

None

Command Modes

Interface configuration mode

Command History

ModificationRelease

This command was introduced.Release 4.2.0

Supported was added for IPv6 prefixes.Release 4.3.0

This command was modified to add the address-unique option for

unclassified-source initiator.

Release 5.2.2

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes appropriate task

IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator

for assistance.

Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,

Release 5.2.x

280

IPoE Commands

ipsubscriber l2-connected

Cisco ASR 9000 Series Command Reference

Other manuals for Cisco ASR 9000 Series