Cisco ASR 9000 Series Command Reference

Examples
This example (not applicable for BNG) shows how to enable IPv6 processing on GigabitEthernet interface
0/1/1/0:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/1/0
RP/0/RSP0/CPU0:router(config-if)# ipv6 enable
For BNG, this example show how to enable IPv6 processing on dynamic template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp foo
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 enable
Related Commands
DescriptionCommand
Displays the usability status of interfaces configured
for IPv6.
show ipv6 interface (BNG), on page 317
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
307
IPv4 and IPv6 Commands
ipv6 enable (BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model