Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference

This is an example of configuring the initiator dhcp command in the Interface configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv6 l2-connected
RP/0/RSP0/CPU0:router(config-if-ipsub-ipv6-l2conn)# initiator dhcp
Related Commands
DescriptionCommand
Displays the ipsubscriber information.show ipsubscriber summary, on page 293
Enables packet-triggered IPv4 or IPv6 routed
subscriber session in an access-interface.
initiator unclassified-ip, on page 274
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
273
IPoE Commands
initiator dhcp