Cisco ASR 9000 Series - Encapsulation Ambiguous Dot1 Q

encapsulation ambiguous dot1q
To configure encapsulated ambiguous VLANs with IEEE 802.1q encapsulation type on an access-interface,
use the encapsulation ambiguous dot1q command in the interface configuration mode. To remove the
encapsulated ambiguous VLANs, use the no form of this command.
encapsulation ambiguous dot1q {any | vlan-id | vlan-range} [second-dot1q {any | vlan-id | vlan-range}]
no encapsulation ambiguous
Syntax Description
Specifies the matching criteria as any VLAN tag in the range 1 to 4094.any
VLAN-ID for the outer and inner VLANs.
The range is from 0 to 4094.
vlan-id
VLAN range for the outer and inner VLANs.
The range is given in comma-separated, or hyphen-separated format, or a
combination of both.
vlan-range
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The support for encapsulation ambiguous dot1q any second-dot1q
{ any | vlan-id} was added.
Release 4.3.1
The support for outer VLAN range was added in BNG.Release 5.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The valid combinations of ambiguous VLAN configurations in BNG, with IEEE 802.1q encapsulation type
are:
•
encapsulation ambiguous dot1q {any | vlan-range }
•
encapsulation ambiguous dot1q vlan-id second-dot1q { any | vlan-range }
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
226
BNG Interface Commands
encapsulation ambiguous dot1q