Cisco ASR 9000 Series - Ppp Ms-Chap

ppp ms-chap
To configure CHAP using the point-to-point protocol, use the ppp ms-chap command in the dynamic template
configuration mode. To disable this feature, use the no form of this command.
ppp ms-chap hostname chap_hostname
no ppp ms-chap
Syntax Description
Sets the MS-CHAP hostname.hostname
Specifies the name of the MS-CHAP hostname.
chap_hostname
Command Default
None
Command Modes
Dynamic template configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template command to enter the dynamic template configuration mode.
Task ID
OperationTask ID
read, writeppp
read, writeaaa
Examples
This is an example of configuring the ppp ms-chap command in the dynamic template configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ppp ms-chap hostname host1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
393
BNG PPP Commands
ppp ms-chap