radius-server key (BNG)
To set the authentication and encryption key for all RADIUS communications between the router and the
RADIUS daemon, use the radius-server key command. To disable the key, use the no form of this command.
radius-server key {0 clear-text-key| 7 encrypted-key| clear-text-key}
no radius-server key
Syntax Description
Specifies an unencrypted (cleartext) shared key.
0 clear-text-key
Specifies a encrypted shared key.
7 encrypted-key
Specifies an unencrypted (cleartext) shared key.
clear-text-key
Command Default
The authentication and encryption key is disabled.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported on BNG.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The key entered must match the key used on the RADIUS server. All leading spaces are ignored, but spaces
within and at the end of the key are used. If you use spaces in your key, do not enclose the key in quotation
marks unless the quotation marks themselves are part of the key.
Task ID
OperationsTask ID
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
42
BNG AAA Commands
radius-server key (BNG)
To Next Page
Loading...
Need help?
General
