pppoe sessions throttle
To set a throttle value for the PPPoE sessions for a particular PPPoE BBA-Group, use the sessions throttle
command in PPPoE BBA-Group configuration mode. To remove the specified throttle value for PPPoE
sessions, use the no form of this command.
sessions {circuit-id| circuit-id-and-remote-id| inner-vlan| mac [access-interface]| mac-iwf access-interface|
outer-vlan| remote-id| vlan} throttle request-count request-period blocking-period
no sessions {circuit-id| circuit-id-and-remote-id| inner-vlan| mac [access-interface]| mac-iwf
access-interface| outer-vlan| remote-id| vlan} throttle request-count request-period blocking-period
Syntax Description
Throttles PPPoE sessions based on any one access
interface
access-interface
Throttles PPPoE sessions with any one circuit-id.circuit-id
Throttles PPPoE sessions by circuit-id and remote-id.circuit-id-and-remote-id
Throttles PPPoE sessions with any one inner-vlan id.inner-vlan
Throttles PPPoE sessions from any one mac address.mac
Throttles Inter-Working Function (IWF) sessions from
any one mac address.
mac-iwf
Throttles PPPoE sessions with any one outer-vlan id.outer-vlan
Throttles PPPoE sessions with any one remote-id.remote-id
Throttles PPPoE sessions with matching vlan ids.vlan
Specifies the action of throttling the PPPoE sessions
for various attributes.
throttle
Specifies the number of session requests allowed
before throttling.
request-count
Specifies the time interval during which the session
requests are counted.
request-period
Specifies the time interval during which no more
requests from the subscriber are accepted, when the
subscriber has already been throttled.
blocking-period
Command Default
Sessions throttle is disabled by default.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
460
PPPoE Commands
pppoe sessions throttle
To Next Page
Loading...
