Cisco ASR 9000 Series Command Reference

interface-list
To configure the interface list (mapping list of all access ports) that are part of a specific subscriber redundancy
group (SRG), use the interface-list command in subscriber redundancy group configuration mode. To remove
the interface list configuration, use the no form of this command.
interface-list [interface interface-type interface-name {id interface-id| sub-if-range sub-if-start-range
sub-if-end-range id-range id-start-range id-end-range}]
no interface-list [interface interface-type interface-name {id interface-id| sub-if-range sub-if-start-range
sub-if-end-range id-range id-start-range id-end-range}]
Syntax Description
Specifies the mapping identifier of the interface-list.
The identifier for particular interface must be same on both master and slave
nodes.
id
Identifier value for the interface to be mapped on to the slave SRG.
interface-id
Specifies the range of sub-interfaces to be added for the given interface.sub-if-range
Start value of sub-interface range.
The range is from 0 to 2147483647.
sub-if-start-range
End value of sub-interface range.
The range is from 0 to 2147483647.
sub-if-end-range
Specifies the range of interface-list identifiers.id-range
Start ID of the interface to be mapped on to the SRG peer.
The range is from 1 to 65535.
id-start-range
End ID of the interface to be mapped on to the SRG peer.
The range is from 1 to 65535.
id-end-range
Command Default
None
Command Modes
Subscriber redundancy group configuration.
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
520
Subscriber Commands
interface-list

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model