event
To configure a policy event, use the event command in policy-map configuration mode. To disable an event
and exit the policy-map configuration mode, use the no form of this command.
event{ account-logoff | account-logon | authentication-failure | authentication-no-response |
authorization-failure | authorization-no-response | exception [match-all | match-first] | idle-timeout |
service-start | service-stop | session-activate | session-start | session-stop | timer-expiry }
no event{ account-logoff | account-logon | authentication-failure | authentication-no-response |
authorization-failure | authorization-no-response | exception [match-all | match-first] | idle-timeout |
service-start | service-stop | session-activate | session-start | session-stop | timer-expiry }
Syntax Description
Specifies an account logoff event.account-logoff
Specifies an account logon event.account-logon
Specifies an authentication failure event.authentication-failure
Specifies an authentication no response event.authentication-no-response
Specifies an authorization failure event.authorization-failure
Specifies an authorization no response event.authorization-no-response
Specifies a service rollback failure event due to a
multi-action CoA (MA - CoA) request failure.
exception
Specifies an idle timeout event.idle-timeout
Specifies a service start event.service-start
Specifies a service stop event.service-stop
Specifies session activate event.session-activate
Specifies session start event.session-start
Specifies session start event.session-stop
Specifies the timer expiry event.timer-expiry
Command Default
None
Command Modes
Policy-map configuration
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
124
Control Policy Commands
event
To Next Page
Loading...
Need help?
General
