Cisco ASR 9000 Series - Shape Average (BNG)

shape average (BNG)
To shape traffic to the indicated bit rate according to the algorithm specified, use the shape average command
in policy map class configuration mode. To remove traffic shaping, use the no form of this command.
shape average {percent {percentage | $shape-rate = percentage} | rate [ units ] | per-thousand value |
per-million value | $shape-rate = rate [ units ]}
no shape average
Syntax Description
Specifies the interface bandwidth in percentage. Values can be from 1 to 100.
percent percentage
Average shaping rate in the specified units. Values can be from 1 to
4294967295.
rate
(Optional) Units for the bandwidth. Values can be:
• Excess burst size—values can be from 1 to 4294967295
• bps—bits per second (default)
• gbps—gigabits per second
• kbps—kilobits per second
• mbps—megabits per second
units
Specifies shape rate as parts per thousand of the available bandwidth.
per-thousand value
Specifies shape rate as parts per million of the available bandwidth.
per-million value
Specifies that a QoS shaper variable is configured.$
QoS shaper variable name that can be parameterized.
shape-rate
Command Default
units: bps
Command Modes
Policy map class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
$shape-rate =rate option was added to support QoS shaper
parameterization in BNG.
Release 5.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
489
QOS Commands
shape average (BNG)