Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference

Either a physical interface instance or a virtual interface instance as follows:
•
Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the modular services card or line card.
◦
module: Module number. A physical layer interface module (PLIM) is always
0.
◦
port: Physical port number of the interface.
In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RSP0 ) and the
module is CPU0. Example: interface MgmtEth0/RSP0 /CPU0/0.
Note
•
Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Displays the Excessive Punt Flow Trap feature information.information
Displays bad actors on a line card.location
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationTask ID
readlpts
read, writebasic-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
261
Excessive Punt Flow Trap Commands
show lpts punt excessive-flow-trap