igmp explicit-tracking
To configure explicit host tracking under Internet Group Management Protocol (IGMP) Version 3, use the
igmp explicit-tracking command in the dynamic-template configuration mode. To disable explicit host
tracking, use the no form of this command.
igmp explicit-tracking access_list_name
no igmp explicit-tracking
Syntax Description
Specifies the access list tracking group range.
access_list_name
Command Default
None
Command Modes
Dynamic template configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the dynamic-template type ppp command to enter dynamic template type ppp configuration mode.
Task ID
OperationTask ID
read, writemulticast
Examples
This is an example of configuring the igmp explicit-tracking command in the dynamic-template configuration
mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template
RP/0/RSP0/CPU0:router(config-dynamic-template)# type ppp foo
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# igmp explicit-tracking igmp1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
336
Multicast Commands
igmp explicit-tracking
To Next Page
Loading...
