Cisco ASR 9000 Series Command Reference

profile (BNG)
To specify a DHCP profile for the Dynamic Host Configuration Protocol (DHCP) IPv4 and IPv6 component
and to enter the profile mode, use the profile command in DHCP IPv4 or DHCP IPv6 configuration submode.
To disable a profile and exit the profile mode, use the no form of this command.
profile profile_name {base | proxy | server }
no profile profile_name {base | proxy | server }
Syntax Description
Specifies the name of the profile
that uniquely identifies the proxy
or server.
profile_name
Creates a DHCP base profile.base
Creates a DHCP proxy profile.proxy
Creates a DHCP server profile.server
Command Default
None
Command Modes
DHCP IPv4 configuration
DHCP IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support was added for IPv6.Release 4.3.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationsTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
180
BNG DHCP Commands
profile (BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model