Cisco ASR 9000 Series - Inner-Cos

inner-cos
To reset the default inner-cos value for DHCPv4 control packets sent on BNG subscriber interfaces, use the
inner-cos command in DHCP IPv4 configuration mode. To set the inner-cos value back to the default value,
use the no form of this command.
inner-cos value
no inner-cos value
Syntax Description
Value of inner-cos for DHCPv4 control packets.
The range is from 0 to 7.
value
Command Default
None
Command Modes
DHCP IPv4 configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Task ID
OperationTask ID
read, writeip-services
Examples
This example shows how to reset the default inner-cos value for DHCPv4 control packets sent on BNG
subscriber interfaces:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# inner-cos 0
Related Commands
DescriptionCommand
Resets the default outer-cos value for DHCPv4 control packets sent
on BNG subscriber interfaces.
outer-cos, on page 178
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
161
BNG DHCP Commands
inner-cos