Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference

Dynamic ARP Inspection (DAI)
ICMP 10 - 15 - ICMP
ICMP-local
ICMP-app
ICMP-control
ICMP-default
DHCP 10 - 15 - DHCP Snoop Request
DHCP Snoop Reply
PPPOE 10 25 15 - PPP over Ethernet (PPPoE)
PPPoE packets for RSP
PPPoE packet/config mismatch
PPPoE packet/config mismatch for RSP
PPP 10 - 15 - Point-to-Point Protocol (PPP)
PPP packets for RSP
IGMP 10 - 15 - IGMP
IGMP Snoop
MLD Snoop
IPv4/v6 10 - 15 - IP Subscriber (IPSUB)
IPv4 options
IPv4 FIB
IPv4 TTL exceeded
IPv4 fragmentation needed
IPv4/v6 adjacency
IPV4/v6 unknown IFIB
UDP-known
UDP-listen
Generic Routing Encap (GRE) bad flags
UDP-default
TCP-known
TCP-listen
TCP-cfg-peer
TCP-default
Raw-listen
Raw-default
L2TP 10 - 15 - Layer 2 Tunneling Protocol, version 2 (L2TPv2)
L2TPv2-default
L2TPv2-known
L2TPv3
The corresponding show running-config output for the above show lpts punt excessive-flow-trap information
command is:
RP/0/RSP0/CPU0:router# show running-config lpts punt excessive-flow-trap
lpts punt excessive-flow-trap
penalty-rate arp 15
penalty-rate pppoe 25
penalty-timeout arp 2
non-subscriber-interfaces
This table describes the significant fields shown in the display.
Table 12: show lpts punt excessive-flow-trap information Field Descriptions
DescriptionField
The penalty policing rate for a protocol. For arp the
value is 15 and for pppoe the value is 25.
penalty-rate
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
264
Excessive Punt Flow Trap Commands
show lpts punt excessive-flow-trap information