pado delay service-name
To set a delay for a PPPoE Active Discovery Offer (PADO) message for a particular PPPoE BBA-Group,
based on the Service-Name received in PPPoE Active Discovery Initiator (PADI) message, use the pado
delay service-name command in PPPoE BBA-Group configuration mode. To disable the PADO delay
configuration based on the Service-Name, use the no form of this command.
pado delay service-name {string | contains} string delay
no pado delay service-name {string | contains} string delay
Syntax Description
Delays the PADO message, when the Service-Name
string received in PADI message matches the
configured string.
string
Delays the PADO message, when the Service-Name
received in PADI message contains the configured
string.
contains
String received in PADI message, that needs to be
matching the Service-Name (when used along with
string keyword) or the string received in PADI
message, that needs to be contained within the
Service-Name (when used along with the contains
keyword).
string
Delay value for PADO message, in milliseconds,
based on the Service-Name.
The range is from 0 to 10000.
delay
Command Default
None
Command Modes
PPPoE BBA-Group configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
448
PPPoE Commands
pado delay service-name
To Next Page
Loading...
