Cisco ASR 9000 Series Command Reference

show pool vrf
To show the status of VRF pool, use the show pool vrf command in the EXEC mode.
show pool vrf vrf_name{ipv4|ipv6}
Syntax Description
Specifies the vrf name.
vrf_name
Displays all vrfs.all
Specifies the IPv4 pool.ipv4
Specifies the IPv6 pool.ipv6
Specifies the output modifiers.|
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6
pool configuration submode.
Task ID
OperationTask ID
readip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
109
Address Pool Service Commands
show pool vrf

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model