ipv6 access-group (BNG)
To control access to an interface, use the ipv6 access-group command in interface configuration mode. To
remove the specified access group, use the no form of this command.
ipv6 access-group [common access-list-name ] access-list-name {ingress| egress}
[interface-statistics][compress level level]
no ipv6 access-group [common access-list-name ] access-list-name {ingress| egress}
[interface-statistics][compress level level]
Syntax Description
Name of an IPv6 access list as specified by an ipv6 access-list
command.
access-list-name
Specifies the common access-list name.
common access-list-name
Filters on inbound packets.ingress
Filters on outbound packets.egress
(Optional) Specifies per-interface statistics in the hardware.interface-statistics
Specifies ACL compression in the hardware. The available
compression levels are 0, 1, and 3.
compress level level
Command Default
The interface does not have an IPv6 access list applied to it.
Command Modes
Interface configuration
L2 transport
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Support for IPv6 ACL on L2 transport interface was added.Release 4.3.0
The common keyword was added.
The compress level keyword was added.
Release 4.3.1
Usage Guidelines
The ipv6 access-group command is similar to the ipv4 access-group command, except that it is IPv6-specific.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
71
ACL and ABF Commands
ipv6 access-group (BNG)
To Next Page
Loading...
Need help?
General
