Cisco ASR 9000 Series Command Reference

radius-server deadtime (BNG)
To improve RADIUS response times when some servers are unavailable and cause the unavailable servers to
be skipped immediately, use the radius-server deadtime command. To set deadtime to 0, use the no form
of this command.
radius-server deadtime value
no radius-server deadtime value
Syntax Description
Length of time, in minutes, for which a RADIUS server is skipped over by transaction
requests, up to a maximum of 1440 (24 hours). The range is from 1 to 1440. The default
value is 0.
value
Command Default
Dead time is set to 0.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported on BNG.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
A RADIUS server marked as dead is skipped by additional requests for the duration of minutes unless all
other servers are marked dead and there is no rollover method.
Task ID
OperationsTask ID
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
35
BNG AAA Commands
radius-server deadtime (BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model