Cisco ASR 9000 Series - Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference

The exclude command can be configured along with the network, address-range, and the prefix-range
commands.
Note
Task ID
OperationTask ID
read, writeip-services
Examples
This is an example to configure the exclude command for IPv4:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv4 pool2
RP/0/RSP0/CPU0:router(config-pool-ipv4)# exclude 10.10.10.1 10.10.10.10
This is an example to configure the exclude command for IPv6:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# pool vrf vrf1 ipv6 pool3
RP/0/RSP0/CPU0:router(config-pool-ipv6)# exclude 2001::1
Related Commands
DescriptionCommand
Enables distributed address pool service on IPv4.pool ipv4, on page 92
Enables distributed address pool service on vrf.pool vrf, on page 90
Specifies a set of addresses or prefixes inside a
subnet.
network (BNG), on page 84
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
83
Address Pool Service Commands
exclude