Cisco ASR 9000 Series Command Reference

show pool ipv6 name
To show the status of an IPv6 pool, use the show pool ipv6 name command in the EXEC mode.
show pool ipv6 name pool_name{location| verbose| }
Syntax Description
Specifies the name of the IPv6 pool.
pool_name
Specifies the location of the IPv6 pool.location
Displays all allocations for the pools.verbose
Specifies the output modifiers.|
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Use thepool ipv6 command to enter Pool IPv6 configuration submode.
Task ID
OperationTask ID
readip-services
Examples
This is the sample output for the show pool ipv6 name command:
RP/0/RSP0/CPU0:router# show pool ipv4 name POOL_A6_i_1
Pool POOL_A6_i_1 Allocations
---------------------------------------------------
VRF: vrf1
Pool Id: 1
Pool Scope: VRF Specific Pool
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
102
Address Pool Service Commands
show pool ipv6 name

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model