Cisco ASR 9000 Series Command Reference

OperationsTask ID
read, writeconfig-services
Examples
This example (not applicable for BNG) configures the “other stateful configuration” flag in IPv6 router
advertisements on GigabitEthernet interface 0/1/1/0:
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/1/0
RP/0/RSP0/CPU0:router(config-if)# ipv6 nd other-config-flag
For BNG, this example configures the “other stateful configuration” flag for IPv6 router advertisements in the
dynamic template configuration mode:
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp p1
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# ipv6 nd other-config-flag
Related Commands
DescriptionCommand
Sets the managed address configuration flag in IPv6
router advertisements.
ipv6 nd managed-config-flag (BNG), on page 358
Displays the usability status of interfaces configured
for IPv6.
show ipv6 interface (BNG), on page 317
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
364
Neighbor Discovery Commands
ipv6 nd other-config-flag (BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model