Usage Guidelines
There are seven possible PPP states applicable for either the Link Control Protocol (LCP) or the Network
Control Protocol (NCP).
The command output displays a summary of the interface as it is in the PPP Interface Descriptor Block (IDB).
The output includes the following information (where applicable):
•
Interface state
•
Line protocol state
•
Link Control Protocol (LCP) state
•
Network Control Protocol (NCP) state
•
Multilink PPP state
•
Multilink PPP configuration
•
Keepalive configuration
•
Authentication configuration
•
Negotiated MRUs
•
Negotiated IP addresses
This command can display information for a single interface, all interfaces on a specified node, or all interfaces
on the router.
Task ID
OperationsTask ID
readppp
Examples
This example shows how to display PPP state information for a POS interface:
RP/0/RSP0/CPU0:router# show ppp interface POS 0/2/0/3
POS0/2/0/3 is up, line protocol is up
LCP: Open
Keepalives enabled (10 sec)
Local MRU: 4470 bytes
Peer MRU: 4470 bytes
Authentication
Of Us: CHAP (Completed as 'test-user')
Of Peer: PAP (Completed as 'peer-user')
CDPCP: Listen
IPCP: Open
Local IPv4 address: 55.0.0.1
Peer IPv4 address: 55.0.0.2
Peer DNS Primary: 55.0.0.254
Peer DNS Secondary: 155.0.0.254
IPV6CP: Open
Local IPv6 address: fe80::3531:35ff:fe55:5747/128
Peer IPv6 address: fe80::3531:35ff:fe55:4213/128
MPLSCP: Stopped
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
398
BNG PPP Commands
show ppp interfaces (BNG)
To Next Page
Loading...
Need help?
General
