DescriptionField
Open System Interconnection Control Protocol
(OSICP) state. The possible states that may be
displayed are as follows:
• Initial—Lower layer is unavailable (Down), and
no Open has occurred. The Restart timer is not
running in the Initial state.
• Starting—An administrative Open has been
initiated, but the lower layer is still unavailable
(Down). The Restart timer is not running in the
Starting state. When the lower layer becomes
available (Up), a Configure-Request is sent.
• Closed— OSICP is not currently trying to
negotiate.
• Stopped—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
• Closing—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received. Upon
reception of a Terminate-Ack, the Closed state
is entered. Upon the expiration of the Restart
timer, a new Terminate-Request is transmitted,
and the Restart timer is restarted. After the
Restart timer has expired Max-Terminate times,
the Closed state is entered.
• Stopping—A Terminate-Request has been sent
and the Restart timer is running, but a
Terminate-Ack has not yet been received.
Req-Sent.
• ACKsent—OSICP has received a request and
has replied to it.
• ACKrcvd—OSICP has received a reply to a
request it sent.
• Open—OSICP is functioning properly.
OSICP
IPv4 address for the peer equipment.Peer IPv4 address
Maximum receive unit. The maximum size of the
information transported, in bytes, in the PPP packet
received by the peer equipment.
Peer MRU
Configuration request was sent; waiting for peer to
respond.
Req-Sent
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
403
BNG PPP Commands
show ppp interfaces (BNG)
To Next Page
Loading...
