Cisco ASR 9000 Series Command Reference

Usage Guidelines
You can attach a single policy map to one or more interfaces to specify the service policy for those interfaces.
The class policies composing the policy map are then applied to packets that satisfy the class map match
criteria for the class. To apply a new policy to an interface, you must remove the previous policy. A new
policy cannot replace an existing policy.
To enter the dynamic template configuration mode, run dynamic-template command in the Global
Configuration mode.
Task ID
OperationsTask ID
read, writeqos
Examples
This example shows policy map policy1 applied to Packet-over-SONET/SDH (POS) interface 0/2/0/0:
RP/0/RSP0/CPU0:router(config)# class-map class1
RP/0/RSP0/CPU0:router(config-cmap)# match precedence ipv4 1
RP/0/RSP0/CPU0:router(config-cmap)# exit
RP/0/RSP0/CPU0:router(config)# policy-map policy1
RP/0/RSP0/CPU0:router(config-pmap)# class class1
RP/0/RSP0/CPU0:router(config-pmap-c)# set precedence 2
RP/0/RSP0/CPU0:router(config-pmap)# exit
RP/0/RSP0/CPU0:router(config)# interface POS 0/2/0/0
RP/0/RSP0/CPU0:router(config-if)# service-policy output policy1
This example shows policy map policy2 applied to GigabitEthernet subinterface 0/1/0/0.1.
RP/0/RSP0/CPU0:router(config)# class-map class2
RP/0/RSP0/CPU0:router(config-cmap)# exit
RP/0/RSP0/CPU0:router(config)# policy-map policy2
RP/0/RSP0/CPU0:router(config-pmap)# class-map class2
RP/0/RSP0/CPU0:router(config-pmap-c)# set precedence 3
RP/0/RSP0/CPU0:router(config-pmap)# exit
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/0.1
RP/0/RSP0/CPU0:router(config-subif)# service-policy input policy2 shared-policy-instance
ethernet101
This example does not apply to BNG.Note
This example shows policy map policy 1 applied to Bundle-Ether interfaces 100.1 and 100.2
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100.1
RP/0/RSP0/CPU0:router(config-if)# service-policy policy1 shared-policy-instance subscriber1
RP/0/RSP0/CPU0:router(config-if)# exit
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100.2
RP/0/RSP0/CPU0:router(config-if)# service-policy output policy1 shared-policy-instance
subscriber1
.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
487
QOS Commands
service-policy (interface BNG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model