Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Task ID
OperationTask ID
readnetwork
Examples
This is the sample output of the show subscriber manager statistics command in the EXEC mode mode:
RP/0/RSP0/CPU0:router# show subscriber manager statistics summary total
The show subscriber manager statistics output is as follows:
Wed Jan 23 09:57:41.855 GMT
[ IEDGE SUMMARY STATISTICS ]
Location: 0/0/CPU0
IEDGE SUMMARY
=============
Control Policy errors
Subscriber control policy not applied on interface = 0
No class match in Start Request = 0
Attribute format warnings
NAS Port = 0
NAS Port id = 0
Destination station id = 0
Calling station id = 0
User Name = 0
User Profile Statistics
User Profile Install = 0
User Profile Install errors = 0
User Profile Removes = 0
User Profile Errors = 0
Session Disconnect Flow Control
Inflight = 0
Queued = 0
Location: 0/1/CPU0
IEDGE SUMMARY
=============
Control Policy errors
Subscriber control policy not applied on interface = 0
No class match in Start Request = 0
Attribute format warnings
NAS Port = 72
NAS Port id = 0
Destination station id = 72
Calling station id = 72
User Name = 0
User Profile Statistics
User Profile Install = 0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
550
Subscriber Commands
show subscriber manager statistics
To Next Page
Loading...
