DescriptionSetting
From the drop-down list, choose the calling party transformation
pattern for the PSTN connection.
Choose one of the following from the drop-down list and click Save.
• Automatic—Select this option to use the calling party
transformation pattern based on the dial plan. Click View to
view the calling party transformation.
The Calling Party Transformation patterns will not
displayed until the PSTN connection has been created.
You must configure the PSTN connection and then
edit to view or modify the transformation pattern.
Note
For information on configuring the calling party
transformation, see digit discard instructions, see Calling Party
Transformations Settings, on page 310.
• Set Manually—Select this option to manually configure the
calling party transformation pattern.
Click Edit to edit the digit discard instructions.
The Calling Party Transformation patterns will not
displayed until the PSTN connection has been created.
You must configure the PSTN connection and then
edit to view or modify the transformation pattern.
Note
The calling party transformation patterns that appears when
you edit the PSTN connection, depend on the numbering plan
that you choose from the Dial Plan drop-down list on the
System Settings > Dial Plan > General tab.
Calling Party Transformations
Connection Type: SIP Trunk
The following table describes the settings on the Add PSTN Connection > Connection Settings page when
your chosen Connection Type is SIP trunk.
Table 68: Connection settings for SIP Trunk Connection Type
DescriptionSetting
General Information
Displays the name of the PSTN connection.Connection Name
Displays the description provided for the PSTN connection.Description
Displays the type of PSTN connection.Connection Type
Displays the type of gateway device.Device Type
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 283
Connection Settings
To Next Page
Loading...
Need help?
General
