DescriptionSetting
Long delay consists of the following:
• Ring Delay (sec)
• Answer Delay (sec)
• Ring Duration (sec)
Click Edit to change the configuration settings.
Click Delete to remove the ring timing set. You can delete
Long delay timing only if the Long delay is not in use.
The default value for answer delay is 3.5 seconds and ring
duration is 30 seconds.
If Long Delay is not in use, and if you click delete,
a window appears to confirm delete.
If the Long delay is in use and if you click delete,
the system prompts "The ring timing set 'Long
Delay' cannot be deleted because it is configured
for the users listed below. The Reach Me Anywhere
settings for these users must be switched to a
different ring timing set before this one can be
deleted."
Note
Long Delay
You can add a new customized timing set.Add Ringing Time Set.
The following table describes the fields for Add Ringing Time Settings.
Table 74: Settings on Add Ringing Time
DescriptionField
Name of the profile (Short Delay, Moderate Delay,
Long Delay).
Name field is
mandatory.
Note
Name
The time to wait before ringing alternate number.
The value ranges from 1 to 30 seconds.
You can increment the value by 1
second.
Note
Ring Delay (sec)
Time to wait before allowing connection to alternate
number. Used to avoid immediate forwarding or
voicemail pickup from alternate number. The value
ranges from 0 to 10.
You can increment the value by 0.5
seconds.
Note
Answer Delay (Sec)
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 313
To Next Page
Loading...
Need help?
General
