CONSOLE AI | Managing Channels (CP2) | 238
Option Description
Auto Disconnect Select the auto disconnect mode to control when the unit disconnects a
connected call. Modes include Loop Drop + Call Progress, Call Progress,
and Loop Drop, and Off. Default is Loop Drop + Call Progress.
Ring Type Select from three different ring tones (Type 1, Type 2, Type 3). To test a
particular tone, click Test after you have selected the tone. Default is Type
1.
Telco Adaptation Some applications require the unit to adapt to line conditions using a
white-noise burst (Noise) rather than automatically (Auto). Default is Auto.
Hook Flash Sends a momentary interruption in the line seizure, allowing activation
of options such as 3-way calling, call waiting, and call hold. This feature
is dependent on the services offered by your telephone company. You
can set the duration of the hook flash using the slider or the selector box.
Range is 50ms to 2 seconds in 10ms steps. Defaults is 250ms.
DTMF Level This feature allows you to adjust the DTMF tone level in relationship to the
participant audio level in the room. The level can be adjusted in 1dB steps
from a nominal level of 0dB to plus or minus 12dB in 1dB increments.
Default is 0dB.
Audible Ringer When this feature is enabled, an audible ring is heard for incoming calls.
The level adjustment allows you to customize the level in relationship
to the participant audio level in the room. The level can be adjusted in
1dB steps from a nominal level 0 (default) to plus or minus 12dB in 1dB
increments. Default is 0dB.
Audible Hook When the unit goes off hook (connects) a beep is injected into the receive
channel and transmit channel of the unit. When the unit goes on hook
(disconnects), a series of two beeps is injected into the receive channel to
indicate that the call has been dropped. Default is 0dB.
Ringer Cadence
• Standard: Uses the cadence specified in the Country Code to detect
the standard ring cadence per country.
• Custom: Set for distinctive ring cadences. When custom is set, the
Min On and Min Off times must be selected from their respective
drop-down boxes. PBX’s can have distinctive ring cadences that are
not country specific. These times are the minimum values the ring
cadence must be for the unit to detect the ring. If the ring cadence
signal provided by the PBX is greater than the custom settings, the unit
will detect the ring.
Default is Standard.
Local Number The device’s phone number.
Country Codes Set the country for the device to specify which telco standards are used.
8. Click Close.
Receive Boost
9. To change the Receive Boost gain, drag the slider.
Noise Canceller (NC)
10.To enable and configure the Noise Canceller, click the NC button.
The Noise Canceller dialog box appears:
CONSOLE AI User Manual
To Next Page
Loading...
