CONSOLE AI | Online Mode (CP2) | 289
5. Type the username and password for the device, and then click OK.
Assuming you have provided the correct credentials, you are connected to the device or stack.
Direct Connect
6. If the device you want to connect to isn’t listed, you can also connect to the device by specifying the IP
address manually by clicking Direct Connect.
A warning dialog box appears:
7. If you want to not have this dialog box shown when using Direct Connect, deselect the Show Again
check box.
8. Click OK.
The Direct Connect dialog box appears:
9. Type an IP address, then click Connect.
The Authenticate dialog box appears:
CONSOLE AI User Manual
To Next Page
Loading...
