CONSOLE AI | Glossary | 313
Gating Controls
The gating parameters that are assigned to a gating group, including:
• Maximum Number of Mics. Sets the maximum number of mics that can be gated on simultaneously.
• First Mic Priority. Increases the audio level required to gate on additional microphones after the first
mic is gated on.
• Last Mic Mode. Sets the last-activated mic to Last On, Mic 1-8, or Off.
Gating Groups
A set of gating parameters which can be applied to microphones connected to the stack. Gating groups
provide greater flexibility and control of mics.
GPIO (General Purpose Input/Output)
GPIO connections enable external devices to access the Converge Pro 2 functions, including common
functions such as volume control, muting, room combining, and preset changes.
Hold Time
The length of time that a microphone remains on after the voice (input) level drops below the gate ratio.
This can be used to prevent the microphone from gating off during brief pauses in speech.
Last Mic Mode
Sets the last-activated mic to Last On, Mic 1-8, or Off. The Last On setting leaves the last-activated mic
gated on until another mic input gates on.
Macro
A series of commands stored and executed together. Macros can be executed from within CONVERGE
Pro 2 CONSOLE, using serial commands, and using timers.
Manual Gating
Provides the ability to gate a microphone on or off manually. See also Gating.
Matrix
The Matrix, shown in the MatrixView
™
, displays inputs as rows and outputs as columns and lets you create
connections at cross points (spots in the matrix where input rows and output columns intersect).
Maximum Number of Mics
Sets the maximum number of mics that can be gated on simultaneously. See Gating.
Mute
A condition in which an audio signal is attenuated below the audible threshold.
CONSOLE AI User Manual
To Next Page
Loading...
