D-Link DWL-3500AP

LLDP (802.1AB) Commands 105
2 Switching Commands
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Mode Whether violation traps are enabled.
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format
show port-security dynamic <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of dynamically locked MAC.
show port-security static
This command displays the statically locked MAC addresses for port.
Format
show port-security static <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of statically locked MAC.
show port-security violation
This command displays the source MAC address of the last packet discarded on a locked port.
Format
show port-security violation <slot/port>
Mode Privileged EXEC
MAC Address MAC Address of discarded packet on locked port.
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability.
Default disabled
Format
lldp transmit
Mode Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default.