D-Link DWL-3500AP

68 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format set garp timer leave <20-600>
Modes Interface Config
Global Config
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only
has an effect when GVRP is enabled.
Format
no set garp timer leave
Modes Interface Config
Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates
that all registrations will be unregistered. Participants would need to rejoin in order to maintain
registration. The value applies per port and per GARP participation. The time may range from
200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds. You can use this
command on all ports (Global Config mode) or a single port (Interface Config mode), and it
only has an effect only when GVRP is enabled.
Default 1000
Format
set garp timer leaveall <200-6000>
Modes Interface Config
Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has an
effect when GVRP is enabled.
Format
no set garp timer leaveall
Modes Interface Config
Global Config
show garp
This command displays GARP information.
Format
show garp
Modes Privileged EXEC
User EXEC
GMRP Admin Mode The administrative mode of GARP Multicast Registration Protocol
(GMRP) for the system.
GVRP Admin Mode The administrative mode of GARP VLAN Registration Protocol
(GVRP) for the system