32 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
D-Link Unified Access System CLI Command Reference
Table 6 explains how to enter or exit each mode.
Wireless Config
Mode
Switch (Config-wireless)#
Contains global WLAN switch
configuration commands and
provides access to other WLAN
command modes.
AP Config Mode
Switch (Config-ap)#
Contains commands to config-
ure entries in the local AP data-
base, which is used for AP
validation.
AP Profile Config
Mode
Switch (Config-ap-profile)#
Contains commands to config-
ure the default AP profile set-
tings as well as settings for new
AP profile.
AP Profile Radio
Config Mode
Switch (Config-ap-profile-radio)#
Contains commands to modify
the radio configuration parame-
ters for an AP profile.
AP Profile VAP
Config Mode
Switch (Config-ap-profile-vap)#
Contains commands to config-
ure radio 1 or radio 2 within an
AP profile.
Network Config
Mode
Switch (Config-network)#
Contains commands to config-
ure WLAN settings for up to 64
different networks.
Captive Portal
Config Mode
Switch (Config-CP)#
Contains commands to config-
ure global captive portal settings
Captive Portal
Instance Mode
Switch (Config-CP 1)#
Contains commands to config-
ure a captive portal instance.
Table 6. CLI Mode Access and Exit
Command
Mode
Access Method Exit or Access Previous Mode
User EXEC This is the first level of access. To exit, enter
logout.
Privileged EXEC From the User EXEC mode, enter
enable.
To exit to the User EXEC mode, enter
exit or press Ctrl-Z.
Global Config From the Privileged EXEC mode,
enter
configure.
To exit to the Privileged EXEC mode,
enter exit, or press Ctrl-Z.
VLAN Config From the Privileged EXEC mode,
enter
vlan database.
To exit to the Privileged EXEC mode,
enter exit, or press Ctrl-Z.
Interface Config From the Global Config mode, enter
interface <slot/port> or
interface loopback <id>
or
interface tunnel <id> or
To exit to the Global Config mode,
enter
exit. To return to the Privileged
EXEC mode, enter Ctrl-Z.
Line Config From the Global Config mode, enter
lineconfig.
To exit to the Global Config mode,
enter exit. To return to the Privileged
EXEC mode, enter Ctrl-Z.
Table 5. CLI Command Modes
Command
Mode
Prompt Mode Description
To Next Page
Loading...
