D-Link DWL-3500AP

76 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no dot1x port-control
This command sets the authentication mode on the specified port to the default value.
Format
no dot1x port-control
Mode Interface Config
dot1x port-control all
This command sets the authentication mode to use on all ports. Select force-unauthorized to
specify that the authenticator PAE unconditionally sets the controlled port to unauthorized.
Select
force-authorized to specify that the authenticator PAE unconditionally sets the
controlled port to authorized. Select
auto to specify that the authenticator PAE sets the
controlled port mode to reflect the outcome of the authentication exchanges between the
supplicant, authenticator and the authentication server.
Default auto
Format
dot1x port-control all {force-unauthorized | force-authorized |
auto}
Mode Global Config
no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
Format
no dot1x port-control all
Mode Global Config
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is
only valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an
error will be returned.
Format
dot1x re-authenticate <slot/port>
Mode Privileged EXEC
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default disabled
Format
dot1x re-authentication
Mode Interface Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode Interface Config