IP Access Control List (ACL) Commands 251
5 Quality of Service (QoS) Commands
Format no access-list <accesslistnumber>
Mode Global Config
ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access list
relative to other IP access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface and
direction, the specified access list replaces the currently attached IP access list using that
sequence number. If the sequence number is not specified for this command, a sequence
number that is one greater than the highest sequence number currently in use for this interface
and direction is used.
Default none
Format
ip access-group <accesslistnumber> in [sequence <1-4294967295>]
Modes Interface Config
Global Config
no ip access-group
This command removes a specified IP ACL from an interface.
Default none
Format
no ip access-group <accesslistnumber> in
Mode Interface Config
acl-trapflags
This command enables the ACL trap mode.
Default disabled
Format
acl-trapflags
Mode Global Config
no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode Global Config
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the IP
ACL.
Format
show ip access-lists <accesslistnumber>
Mode Privileged EXEC
To Next Page
Loading...
