D-Link DWL-3500AP

GVRP Commands 69
2 Switching Commands
GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
NOTE: If GVRP is disabled, the system does not forward GVRP messages.
set gvrp adminmode
This command enables GVRP on the system.
Default disabled
Format
set gvrp adminmode
Mode Privileged EXEC
no set gvrp adminmode
This command disables GVRP.
Format
no set gvrp adminmode
Mode Privileged EXEC
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode).
Default disabled
Format
set gvrp interfacemode
Modes Interface Config
Global Config
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All Time have no
effect.
Format
no set gvrp interfacemode
Modes Interface Config
Global Config
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format
show gvrp configuration {<slot/port> | all}