D-Link DWL-3500AP

270 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
logging host
This command enables logging to a host. You can configure up to eight hosts. The <ipaddr> is
the IP address of the logging host. The
<port> value is a port number from 1 to 65535. You
can specify the
<severitylevel> value as either an integer from 0 to 7 or symbolically
through one of the following keywords:
emergency (0), alert (1), critical (2), error (3),
warning (4), notice (5), info (6), or debug (7).
Default
port—514
level—critical (2)
Format
logging host <ipaddr> [<port>][<severitylevel>]
Mode Global Config
logging host remove
This command disables logging to host. See “show logging hosts” on page 271 for a list of
host indexes.
Format
logging host remove <hostindex>
Mode Global Config
logging port
This command sets the local port number of the LOG client for logging messages. The
<portid> can be in the range from 1 to 65535.
Default 514
Format
logging port <portid>
Mode Global Config
no logging port
This command resets the local logging port to the default.
Format
no logging port
Mode Global Config
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range of
1-65535.
Default disabled
Format
logging syslog [port <portid>]
Mode Global Config
no logging syslog
This command disables syslog logging.