144 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
no trapflags
The no version of this command disables Unified Switch SNMP trap groups for wireless
system events. If no parameters are specified, then all traps are disabled.
Format
no trapflags [{ap-failure | ap-state | client-state | peer-ws |
rf-scan | rogue-ap | ws-status}]
Mode Wireless Config
agetime
This command configures database entry age times for the Unified Switch. A time value of 0
indicates entries in the corresponding database will not age and you must manually delete
them.
Default 24 hours
Format
agetime {ad-hoc | ap-failure | client-failure | rf-scan} <0-168>
Mode Wireless Config
ad-hoc Time in hours to maintain an entry in the ad hoc client network list.
ap-failure Time in hours to maintain an entry in the AP association and authentication
failure list.
client-failure Time in hours to maintain an entry in the client association and authentication
failure list.
rf-scan Time in hours to maintain an entry obtained from an RF scan.
0-168 Time in hours from 0 to 168. A value of 0 indicates that entries should never
age out.
no agetime
The no version of this command returns the configured entry age time to the default.
Format
no agetime {ad-hoc | ap-failure | client-failure | client-roam |
rf-scan}
Mode Wireless Config
client roam-timeout
This command configures maximum duration for which a client entry is retained in the client
association database after disassociating from a managed AP. Roam-timeout is the time in
seconds after disassociation for the entry to be deleted from the managed AP client association
database.
Default 30 seconds
Format
client roam-timeout <1-120>
Mode Wireless Config
To Next Page
Loading...
