D-Link DWL-3500AP

312 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format snmp-server community ro <name>
Mode Global Config
snmp-server community rw
This command restricts access to switch information. The access mode is read/write (also
called private).
Format
snmp-server community rw <name>
Mode Global Config
snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
NOTE: For other port security commands, see “Protected Ports Commands” on
page 65.
Default disabled
Format
snmp-server enable traps violation
Mode Interface Config
no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
no snmp-server enable traps violation
Mode Interface Config
snmp-server enable traps
This command enables the Authentication Flag.
Default enabled
Format
snmp-server enable traps
Mode Global Config
no snmp-server enable traps
This command disables the Authentication Flag.
Format
no snmp-server enable traps
Mode Global Config
snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps are sent
only if the broadcast storm recovery mode setting associated with the port is enabled.