176 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
antenna
Use this command to configure antenna diversity on the AP. If the AP has two antenna
connectors, antenna diversity may be used. This can improve performance of the AP because
the best antenna is selected for receive and transmit. However, if there is only one antenna,
then disabling antenna diversity is recommended. Antenna diversity is disabled by default and
antenna 1 (primary antenna) is selected for transmit/receive. This switch CLI command allows
disabling or enabling the antenna diversity in a configuration profile for a radio of the
managed AP.
You can select one of the following antenna modes:
• auto—Set Antenna Diversity mode to auto.
• primary—Select primary antenna for transmit/receive.
• secondary—Select primary antenna for transmit/receive.
Default primary
Format
antenna {auto | primary | secondary}
Mode AP Profile Radio Config
no antenna
Use this command to set the Antenna Diversity feature on the AP to the default value.
Format
no antenna
Mode AP Profile Radio Config
beacon-interval
The command configures the beacon interval for the radio. The beacon interval indicates the
interval at which the AP radio transmits beacon frames.
Default 100 milliseconds
Format
beacon-interval <20-2000>
Mode AP Profile Radio Config
20-2000 Time interval in milliseconds at which the radio sends beacon frames.
no beacon-interval
The no version of this command configures the beacon interval to the default value.
Format
no beacon-interval
Mode AP Profile Radio Config
dtim-period
The command configures the DTIM period for the radio. The DTIM period is the number of
beacons between DTIMs. A DTIM is Delivery Traffic Indication Map which indicates there is
buffered broadcast or multicast traffic on the AP.
To Next Page
Loading...
