304 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Format no sshcon timeout
Mode Privileged EXEC
show ip ssh
This command displays the ssh settings.
Format
show ip ssh
Mode Privileged EXEC
Administrative Mode This field indicates whether the administrative mode of SSH is
enabled or disabled.
Protocol Level The protocol level may have the values of version 1, version 2 or both ver-
sions 1 and version 2.
Connections This field specifies the current SSH connections.
Hypertext Transfer Protocol (HTTP) Commands
This section describes the commands you use to configure HTTP and secure HTTP access to
the switch. Access to the switch by using a Web browser is enabled by default. Everything you
can view and configure by using the CLI is also available by using the Web.
ip http server
This command enables access to the switch through the Web interface. When access is
enabled, the user can login to the switch from the Web interface. When access is disabled, the
user cannot login to the switch's Web server. Disabling the Web interface takes effect
immediately. All interfaces are affected.
Default enabled
Format
ip http server
Mode Privileged EXEC
no ip http server
This command disables access to the switch through the Web interface. When access is
disabled, the user cannot login to the switch's Web server.
Format
no ip http server
Mode Privileged EXEC
ip http secure-server
This command is used to enable the secure socket layer for secure HTTP.
Default disabled
Format
ip http secure-server
Mode Privileged EXEC
To Next Page
Loading...
