140 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
Unified Switch Commands
The commands in this section provide global Unified Switch configuration, status, and
statistics.
wireless
This command enters the Unified Switch global configuration mode.
Format
wireless
Mode Global Config
enable (Wireless Config Mode)
This command enables the Unified Switch functionality.
Default Enable
Format
enable
Mode Wireless Config
no enable
The no version of this command disables the Unified Switch functionality.
Format
no enable
Mode Wireless Config
country-code
This command globally configures the country code for the Unified Switch and all managed
access points. The code may be entered in either upper or lower case. When you change the
country code, the wireless function is disabled and re-enabled automatically. The show
country-code command displays all valid country codes.
Default US
Format
country-code <code>
Mode Wireless Config
code This parameter must identify a valid country code.
no country-code
The no version of this command returns the configured country code to the default.
Format
no country-code
Mode Wireless Config
To Next Page
Loading...
