D-Link DWL-3500AP

284 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
CLI Command Reference
network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool.
The prefix-length is an integer from 0 to 32.
Default none
Format
network <networknumber> [{<mask> | <prefixlength>}]
Mode DHCP Pool Config
no network
This command removes the subnet number and mask.
Format
no network
Mode DHCP Pool Config
bootfile
The command specifies the name of the default boot image for a DHCP client. The
<filename> specifies the boot image file.
Format
bootfile <filename>
Mode DHCP Pool Config
no bootfile
This command deletes the boot image name.
Format
no bootfile
Mode DHCP Pool Config
domain-name
This command specifies the domain name for a DHCP client. The <domain> specifies the
domain name string of the client.
Default none
Format
domain-name <domain>
Mode DHCP Pool Config
no domain-name
This command removes the domain name.
Format
no domain-name
Mode DHCP Pool Config